The service life of the insulating glass production line generally depends on the cleaning section and plate pressing section of the insulating glass production line. How to maintain the cleaning section and plate pressing section of the insulating glass production line is related to the service life of the whole set of insulating glass equipment. Power intelligence shares with you how to maintain the cleaning section and plate pressing section of the insulating glass production line:
Cleaning and drying section of insulating glass production line
中空玻璃生產線清洗機現在大多數廠家用的是不銹鋼，一般不會生銹,那重 點就是毛刷和電機的保養了，毛刷一般能用能長期使用，如果不脫 毛可以一直使用，只是他的下端軸承，因為濕度大容易生銹，造成毛刷銹住、抱死或阻力大等故障，還容易燒掉電機。威力智能提供的中空玻璃生產線的毛刷都是采用進口杜邦絲，清洗效果好， 不易脫 毛，可以長時間使用；而且去掉了海綿輥，既保證了玻璃不會二次污染，采用高壓風機循環熱風，保證吹干效果；再就是下端采用純鋼甚至純銅軸承，大限度的隔絕生銹造成損失等情況的發生。
At present, most manufacturers of hollow glass production line cleaning machines use stainless steel, which generally will not rust. The key point is the maintenance of the brush and motor. The brush can generally be used for a long time. If it does not depilate, it can be used all the time, but its lower bearing is easy to rust due to high humidity, resulting in brush rust, locking or high resistance, and it is easy to burn the motor. The brushes of the insulating glass production line provided by Weili intelligence are imported DuPont silk, which has good cleaning effect, is not easy to depilate, and can be used for a long time; Moreover, the sponge roller is removed, which not only ensures that the glass will not be polluted again, but also adopts high-pressure fan to circulate hot air to ensure the drying effect; Then, pure steel or even pure copper bearings are used at the lower end to greatly isolate the loss caused by rust.
Plate pressing section of insulating glass production line
In addition, the plate press, especially the plate press in the insulating glass production line, has many cylinders and solenoid valves. If you do not pay attention to maintenance, refueling and drainage, it is easy to jam the valve or burn the coil. In particular, the solenoid valve on the suction cup can not be lubricated in the oil-water separator, because there will be oil on the suction cup and pollute the glass. Therefore, you can only unplug the intake pipe of the solenoid valve and add a little lubricating oil with an oil pot.
In addition, the butyl rubber coater also needs attention to maintenance. The cylinder cannot be returned in the cold rubber state, because the rubber and the piston are stuck together in the cold rubber state. If it is forcibly returned, it is easy to pull out the rubber cylinder; In addition, when adding glue, be sure to check the appearance of the rubber block for sundries such as iron pins, small stones and nails, which are easy to scratch the rubber cylinder or block the rubber head.